Supported telemetry-protocols:

- Graupner HoTT V4
- Jeti ExBUS
- Multiplex Sensor BUS V2
- Mikado Vbar Control
- YGE-Protocol for more telemetry-connections for exapmple via S32 (new Jlog)

more protocols coming soon...

All usual informations as current, voltage, capacity, RPM, temperature etc. will be transferred to your transmitter. The amount of data and the characterisation depends on your transmitter/receiver.

• 4 to 8s LiPo, incl under voltage protection by power reduction
• BEC 5,0V – 8,4V
• BEC 12A continuous, 25A Peak

• “T” for Telemetry. following protocols are currently compatible: Mikado VBC, Graupner HoTT V4, Jeti ExBUS, Multiplex Sensor BUS V2, YGE-protocol for different telemetry-connections for example via YGE TexY (Futaba, Spektrum, FrSky, Core), MSH Brain 2 or Spirit FBL

• Update capable (optional USB-Adapter available)

• entirely overhauled hard- and software (32-bit)
• the PWM-frequency will be set automatically to the requirements of the motor
• The specified current is the maximum continuous full power current
• Current limiting
• Disconnectable under voltage detection
• Electronic speed control (Governor- mode)
• Soft start
• super soft startup for scale-helicopters possible (60 sec.)
• Active free-wheel, allowing unlimited part load operation
• Automatic or 6 step adjustable timing
• Adjustable EMK brake
• F3A(Acro brake (brake force control infinitely adjustable)
• Frequency: 16 to 32 kHz
• Speed limit: 240.000 rpm (2- Poles)
• Temperature and overload warning
• Anti- flash: decreases the closing spark
• Basic -Programming with mode programming
• Fine adjustment and selection of telemetry log with the PC Setup
• Suitable USB-adapter optionally available
• dimensions (mm): 76,5×34,5×19,5
• weight without/with cables: 80g/124g:

 Content:
- YGE Saphir 125
- RC-Connection Cable
- Fan
- Sticker
- Manual