More information

Matek F405-OSD BetaFlight STM32F405 Flight Control Board Built-in OSD

Matek F405-OSD BetaFlight STM32F405 Flight Control Board Built-in OSD

FC med OSD

Lagerstatus: På lager

Vanlig pris kr 359,00

Special Price kr 215,40



Firmware based on OpenSource BetaFlight, Matek F405 Target
-16Pin FFC Slot: for FCHUB-6S option connection
-Support 32K Gyro update & 16K PID Loop
-Built in inverter for SBUS input (UART2-RX) 
-WS2812 Led Strip, Beeper & RSSI supported
-Micro SD Slot: support SD/SDHC with FAT32 format, but Max.4G can be used.
-2x LEDs for FC STATUS (Blue, Red)
-6x PWM / DShot outputs
-1x Group of G/S1/S2/S3/S4 pads for 4in1 ESC or ESC sginal group connection
-4x pairs of corner pads for ESC Signal/GND connections
-1x pair I2C pads
-1x Side-press button for BOOT(DFU) mode
-1x 16pin bottom mounted FFC Slot for FCHUB-6S connection

Product Details

Brand: Matek Systems
Item name: Flight Control Board
Size: 36x36mm
Mounting hole: 30.5mm
Weight: 7g
MCU: 168MHz STM32F405RGT6
IMU: ICM-20602 (Sample rate 32kHz max)
OSD: BetaFlight OSD w/ AT7456E chip
Blackbox: MicroSD card slot (SD/SDHC)
Battery Voltage Sensor: 1:10
Currsnt Sensor: No (FCHUB-6S option)
BEC 5V & 10V: No (FCHUB-6S option)
LDO 3.3V: Max.300mA for Spektrum RX 
S1~S6: ESC signal 1~6(PWM, Oneshot, Multishot, DSHORT)
VTX: Video Transmiter Sginal
Cam: Camera video sginal
5V: Power the board from external BEC 5V or output 5V to other devices.
3V3: LDO 3.3V, Max. 300mA
4V5: 4.4~4.8V, the voltage is also supplied when connecting via USB
G: Ground
LED: WS2812 LED sginal output
Buz- & 5V: For active 5V buzzer
VCC: LiPo Voltage input, for bettery voltage detection only.
Curr: External current sensor sginal input (Max.3.3V)
Rssi: Frsky RSSI(PWM) input
SBus: Built in inverter of RX2 for SBUS input
RX1 & TX1: UART1
RX3 & TX3: UART3
RX4 & TX4: UART4 
RX5 & TX5: enslosed in the FFC socket
FC Status: LED0(blue) & LED1(red) indicator
3.3V Status: LED2(red) indicator
Button: Boot(DFU) mode button

TX1, TX3 & TX4 w/o inverter, Can be used for Smartaudio or Tramp VTX directly. Non-inversion hacks must be
required for Frsky Smartport on TX1, TX3 or TX4 DSM2, DSMX, IBUS sginal can also be connected to RX1,RX3
or RX4 PPM share UART2-RX pad


Bredde Nei
Høyde Nei
Lengde Nei


Skriv din egen omtale